Off-road Atlas LogoOff-road Atlas Logo
  • Behind The Wheel
  • How-To
  • News
  • Stories

How to Install a Full Windshield on a Can-Am Commander XT

By Joe Crisan | How-To on May 22, 2021
<1M READ
Share
0

Length: 3:26
Created: May 22, 2021

Transcript

What’s up guys? Are you looking for a full windshield for your Can-Am Commander? SuperATV has you covered and today we’re going to show you how to install one.

[Tools list is shown on screen]

Unbox the Windshield

[00:35] First, remove all the contents out of the packaging and lay everything out. Lay the full windshield up on the machine to ensure that it fits. After you’ve done this, peel the protective film from both sides of the windshield.

Apply the Bulb Seal

[00:56] Apply the bulb seal and run it all the way around the sides and bottom of the windshield. When installing the bulb seal, make sure that the bulb portion is facing toward the bend. Then, cut off all the excess.

Install the Windshield

[01:36] We’re going to install the windshield on the machine. Take the provided hardware from the kit, and get it installed through the windshield to the frame of the machine. Make sure the sealing washer is making contact with the windshield.

Install the Clamps

[02:04] Run the strap through the windshield and then loop it through the clamp. Then, feed the strap back through, pull it, and firmly tighten it. Repeat the same steps for the rest of the three clamps.

Fully Tighten the Hardware

[02:53] Once you fully tighten the hardware, that’s all there is to installing SuperATV’s Can-Am Commander Scratch Resistant Full Windshield. Visit our website to get yours. For more information on this windshield or any of SuperATV’s great products, feel free to give us a call or check us out online. Also, drop a like, comment, and subscribe.

Thanks for watching and we’ll catch you on the next one.

RELATED CONTENT: full windshields9 installation262 UTV windshields58
Share
0

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *



Related

  • How to Install Scratch-Resistant Full Windshield on Polaris RZR Trail S 900

    How-To | 2 MIN READ
  • How to Install a Clutch Kit on a Polaris RZR Trail S 1000

    How-To | 8 MIN READ
  • How to Install a Glass Windshield on a Polaris RZR Turbo S

    How-To | 3 MIN READ
  • How to Install Half Windshield on Polaris RZR Trail 900/S 900/S 1000

    How-To | 2 MIN READ
  • How to Install Fender Flares on a Polaris RZR Trail S 900/RZR Trail S 1000

    How-To | 3 MIN READ
  • How to Install Tie Rods on a Polaris RZR Trail S 1000

    How-To | 4 MIN READ
  • How to Install an Aluminum Roof on a Kawasaki Teryx KRX 1000

    How-To | <1 MIN READ
  • What's the Best UTV with a Dump Bed?

    Behind The Wheel | 6 MIN READ
  • How to Install a Rack and Pinion on a Polaris RZR Trail S 900/RZR S 1000

    How-To | 6 MIN READ
Copyright © 2021 SuperATV. All rights reserved.
SHOP NOW