Off-road Atlas LogoOff-road Atlas Logo
  • Behind The Wheel
  • How-To
  • News
  • Stories

How to Install a Seatbelt Override on a Honda Talon 1000

By Tyler Mingione | How-To on July 14, 2020
<1M READ
Share
0

Length: 2:17
Created: July 14, 2020

Transcript

Are you looking to install harnesses or any other aftermarket seatbelt on your Honda Talon? SuperATV’s got you covered with a seatbelt override, and today we’re gonna show you how to get it installed.

First, open up the door on the driver’s side, and pull on this lever to slide your seat out of the way. Now there’s a rubber cover here. Reach up underneath here and unhook it from the hooks on the sides. Leave the hooks on the front portion of the cover and peel it back.

Installing the Override

[00:54]Now unplug this plug here. For our demonstration, we’re going to remove this zip tie so we can show you better. You don’t have to do this. Stick your finger in here and pull up on this little tab and it’ll separate.

Take the seatbelt override and plug it into the factory harness. Make sure it snaps into place. Then reinstall your rubber cover and your seat and there you have it.

That’s how super quick and easy it is to install SuperATV’s seatbelt override on this Honda Talon 1000. For more information on this seatbelt override or any of SuperATV’s great products, feel free to give us a call at 855-743-3427 or check us out online at SuperATV.com.

Thanks for watching and we’ll catch you next time.

RELATED CONTENT: Honda Talon21 installation262
Share
0

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *



Related

  • How to Install a Plug & Play Turn Signal Kit on a Can-Am Defender

    How-To | 11 MIN READ
  • How to Install a 6" Lift Kit on a Honda Pioneer 1000

    How-To | 12 MIN READ
  • How to Install a Rev1 Clutch Kit on a Polaris RZR XP Turbo S

    How-To | 10 MIN READ
  • How to Install Winch & Winch Mount on a Kawasaki Teryx

    How-To | 6 MIN READ
  • How to Install a Seat Belt Override on a Can-Am Maverick X3

    How-To | 2 MIN READ
  • How to Install a Plug & Play Turn Signal Kit on a Polaris General

    How-To | 8 MIN READ
  • How to Install a Rhino Driveline Prop Shaft on a Polaris RZR 1000

    How-To | 7 MIN READ
  • How to Install Winch & Winch Mount on Polaris RZR 1000

    How-To | 10 MIN READ
  • How to Install RackBoss Rack & Pinion on a Polaris Ranger 900

    How-To | 5 MIN READ
Copyright © 2021 SuperATV. All rights reserved.
SHOP NOW