Length: 3:25
Created: November 1, 2018
Hey guys, Kristen here at SuperATV and today we’re going to install a Kawasaki Teryx 4 flip up windshield. Let’s get started.
[00:16] We’re going to start by installing the bulb seal, and that is going to go on the lower portion of the lower windshield that comes in contact with your hood. Now, you will have to leave this film on for the most part just peel it back enough to get that seal on. To ease installation you may want to soak the bulb seal in hot water prior to installing. Now that you have the seal installed, you can cut off the excess.
Now, we’re going to install the catch and catch support with the provided hardware. Alright, now that we’ve got the bulb seal and catch installed, it is time to get this dude on.
[01:05] Next, we’ll take this and secure it to our roll cage. As you are installing these, be sure not to get them too tight because if you have to adjust this you want to be able to move it. Okay we’ve got that installed so now it is time to put the gasket on. Cut the excess gasket.
Next, we’re going to install the handle and the handle support with the provided hardware. Make sure that this is on the inside of the windshield facing up towards the top portion.
[02:00] Let’s get this upper windshield on. Now we get to install our gas struts. This is going to go on the pivot block into the center hole.
Alright guys, now we have everything installed, so we are going to close it and make sure your latch lines up with your catch. If so, then you’re good to tighten the rest of your hardware up.
Alright guys, so we’ve got this windshield installed and tightened up so it’s time to remove the protective film.
So that wraps up the installation of our Kawasaki Teryx 4 flip up windshield. And for more information on this and other great SuperATV products hop online at SuperATV.com or give us a call at (855)-743-3427.
Thanks for watching and happy riding.
2 Comments
Do you have current instruction for installing a flip up windshield on a Kawasaki KRX? This video is similar but quite different in a number of things including enclosed hardware kit. There are two flip up latches as well as extra support rings and quite a bit of additional seal material.
Any additional pictures or instructions would be helpful. I’m sure I can figure it out but it would be nice to know exactly what the intended purpose is for all of this?
Hey Howard,
We do offer instructions on the website! Give us a call if you need any further help.