Off-road Atlas LogoOff-road Atlas Logo
  • Behind The Wheel
  • How-To
  • News
  • Stories

How to Install Mud Flaps on a Polaris RZR XP Turbo

By Megan Randall | How-To on October 11, 2021
<1M READ
Share
0

Length: 2:14
Created: October 11, 2021

Transcript

[0:00] Are you looking for a little bit more protection on your trailing arms on your RZR XP 1000 or RZR XP Turbo? SuperATV has the solution with their heavy-duty Mud Flaps and today we’re going to show you how to install them. So let’s get right to it.

The first thing we’ll do is remove the lower bolt and sway bar link. We’re working on the passenger side so we’ll go ahead and get this passenger side bracket back into position. Then we’ll fully tighten it.

Line Up the Mud Flaps

[1:03] Next, take the mud flap. We want it aligned with the side of the trailing arm. We’re on a stock trailing arm so we’re going to use these outside holes. If you have a SuperATV trailing arm, you’ll use the inside holes and these center holes.

You want to adjust it so the bottom of the flap is touching the trailing arm.

Fully Tighten All Hardware

Then we’ll fully tighten all the hardware. Once it’s adjusted, repeat the same steps for the opposite side.

And that’s all there is to it! That’s how you install SuperATV’s Heavy-Duty Mud Flaps on this Polaris RZR XP Turbo. For more information on these mud flaps, check out our website where you can pick up yours today. Thanks for watching and we’ll catch you on the next one!

RELATED CONTENT: installation262 Polaris RZR XP Turbo22
Share
0

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *



Related

  • How to Install a 4500 Lb. Black Ops Winch and Winch Mount on a Honda Talon

    How-To | 12 MIN READ
  • How to Install a 4500 Lb. Black Ops Winch on a Polaris RZR

    How-To | 12 MIN READ
  • How to Install a Winch-Ready Bumper and Black Ops Winch on a Polaris Ranger XP 1000

    How-To | 12 MIN READ
  • How to Install a 6" GDP Portal Gear Lift on a Can-Am Defender

    How-To | 17 MIN READ
  • How to Install a Heavy-Duty Radiator on a Polaris General

    How-To | 8 MIN READ
  • How to Install a Heavy-Duty Carrier Bearing on a Polaris Ranger Crew

    How-To | 11 MIN READ
  • How to Install a 3" Lift Kit on a Polaris RZR XP 1000

    How-To | 5 MIN READ
  • How to Install a 4" GDP Portal Gear Lift on a Polaris RZR PRO XP

    How-To | 13 MIN READ
  • How to Install a High Gear Kit and Clutch Kit on a Polaris RZR XP Turbo

    How-To | 18 MIN READ
Copyright © 2021 SuperATV. All rights reserved.
SHOP NOW