Off-road Atlas LogoOff-road Atlas Logo
  • Behind The Wheel
  • How-To
  • News
  • Stories

How to Install SuperATV’s Spare Tire Carrier on the Can-Am Maverick X3

By Tyler Mingione | How-To on May 1, 2019
<1M READ
Share
0

Length: 3:26
Created: May 1, 2019

Hey everybody. Today we’re going to be installing a spare tire carrier on this Can-Am Maverick X3. So let’s get started.

First, remove the four allen-head screws connecting the lower portion of the clamp to the spare tire carrier. Then place the spare tire carrier onto the center bar here on the machine. Open the hardware pack and get out two bolts and nylock nuts. Insert the bolts from the back facing inward through the holes in the cage of the machine and through the holes on the spare tire carrier. Start your nut from the inside. Then repeat these steps for the opposite side.

01:25
Grab the lower half of the clamp and hardware and attach it to the spare tire carrier. Don’t tighten any of this hardware yet. Just run it down far enough so that it stays in place. Next, fully tighten the bolts in the upper portion of the spare tire carrier. Now tighten the allen headed screws on the lower section in a cross pattern.

02:15
Now you can mount your spare tire. Once it’s lined up, take the provided lug nuts and get them started. Makes sure they’re all straight then tighten them down. There’s no need to get them super tight, just make sure it’ll stay in place.

And there you have it. That’s how super quick and easy it is to install SuperATV’s spare tire carrier to a Can-Am Maverick X3. For more information on this spare tire carrier or any of SuperATV’s great products, give us a call at 855-743-3427, or check us out online at SuperATV.com.

Thanks for watching and have a great day.

RELATED CONTENT: Can-Am Maverick X323 installation262 spare tire carriers9
Share
0

Leave a Reply Cancel reply

Your email address will not be published. Required fields are marked *



Related

  • How to Install Winch & Winch Mount on Polaris RZR 1000

    How-To | 10 MIN READ
  • How to Install 4" GDP Portals on a Polaris RZR Turbo S

    How-To | 5 MIN READ
  • How to Install a 6" Lift Kit on a Honda Pioneer 1000

    How-To | 12 MIN READ
  • How to Install a Gen 3 GDP Portal Gear Lift on a Polaris RZR XP 1000

    How-To | 8 MIN READ
  • How to Install EZ-STEER Power Steering Kit on Polaris RZR 900

    How-To | 5 MIN READ
  • How to Install a Plug & Play Turn Signal Kit on a Can-Am Defender

    How-To | 11 MIN READ
  • How to Install High Clearance A-Arms on a Honda Talon 1000R

    How-To | 6 MIN READ
  • How to Install High Clearance Forward Offset A-Arms on the Polaris RZR PRO XP

    How-To | 9 MIN READ
  • How to Install a Rev1 Clutch Kit on a Polaris RZR XP Turbo S

    How-To | 10 MIN READ
Copyright © 2021 SuperATV. All rights reserved.
SHOP NOW