Length: 2:40
Created: April 30, 2024
What’s up guys, Braden here with SuperATV. Today we’re going to be showing you how to install SuperATV’s full windshield on this Can-Am Defender. So, let’s get right to it!
Unbox and Check Fit: First, take your windshield out of the box. Confirm that it fits your machine by laying it on the Can-Am Defender. Once confirmed, remove the protective film from both sides of the windshield.
Position and Install the Windshield: Grab the windshield and position it on the machine. Install the clamps by sliding the strap through the windshield from the inside. Then, slide it through the clamp and get it started, but do not fully tighten yet. Repeat these steps on the opposite side.
Securing the Windshield: Sometimes the bulb seal can make it tight to install the clamps. If needed, give it a nice tap to ensure it pops through correctly. Once all clamps are in place and the windshield is positioned correctly, fully tighten the straps.
Secure the Windshield: Ensure that the windshield is properly aligned. Fully tighten down all straps to secure the windshield in place. Alright guys, so that’s all there is to it to install SuperATV’s full windshield on this Can-Am Defender. Be sure to check the description below to pick yours up today, and while you’re there, drop a like, comment, and subscribe. Thanks for watching, and we’ll catch you on the next one.
